HowTo Compile In Slackware

Installing aMule on Slackware

by Mike (servnov)

NOTE: you will need super-user (usually root) access to complete aMule install/uninstallation/update.

Installation

Installing wxGTK

Download wxGTK sources (.tar.gz packages) from http://www.amule-project.net or http://www.amule.org and do the following:

tar -xzvf wxGTK*

cd wxGTK*

./configure

make

#the following command must be run as super-user (usually root):

make install

Installing wxBase (Optional)

If you downloaded wxGTK earlier than version 2.5 and you are planning to use aMule with command line interface (such as aMuleCMD, aMuleWeb, aMuled, etc), then you you should install wxBase. In any other case, there's no need at all.

Download wxBase sources (.tar.gz packages) from http://www.amule-project.net or http://www.amule.org and do the following:

tar -xzvf wxBase*

cd wxBase*

./configure

make

#the following command must be run as super-user (usually root):

make install

Installing aMule

Grab pre-built Slackware package from linuxpackages.net.

installpkg aMule-2.0.0rc7-i686-1.tgz (or whatever the newest version is)

That's all!

Type amule in a shell to lauch or in KDE (similar in GNOME) go to Kstart->Internet->aMule

Updating

The following command will remove the old aMule package and install the new version:

upgradepkg aMule-2.0.0rc7-i686-1.tgz

Uninstallation

The following command will remove aMule:

removepkg aMule

Final note

You can even get wxBase and wxGTK .tgz Slackware packages and install them with 'installpkg'. Using the Slackware package manager saves time during installation and makes upgrading easy. You can also type 'pkgtool' as root and then search for the packages you have downloaded and install and/or remove packages.

Enjoy the hard work aMule developers have done and continue to do!

Just remember you will need wxBase and wxGTK installed even when using Slackware package.

---

Hope this helps.

Catch me on IRC at irc.freenode.com channel #amule nick servnov.